What is Dialogue coding?

Dialogue code is an algorithm that provides reliable protection against all known code grabbers. If do not go into details, then both the remote control and the main unit of the alarm system are taken care of by a special encryption algorithm. Instead of the usual procedure (sending a command -> executing a command), main unit using a dialog code with individual encryption keys follows a more secure procedure (sending a command -> checking the sender -> confirming the sender -> executing a command).

Remote control sends to main unit the command command, for example, disarming. The alarm system cannot execute the command until be sure that the command was sent by "its" remote control. Therefore, it sends an encrypted message to the remote control to check for the correct encryption keys. Remote control receives the encrypted message and encrypts it again, according to its encryption algorithm, and sends it back to the main unit. If the received message is correct, the command is executed. The dialogue code ensures the highest degree of safety for your vehicle.

  Security and Service functions

• Interactive DIALOGUE code with individual encryption keys.
• Transmission of alarm notification signals to the remote control with feedback,
• Immobilizer mode.
• Turbo timer mode.
• Anti-theft / Anti Hi-jack mode.
• Programmable 2-step disable engine locks.
• Programmable personal emergency code.
• ARM with engine running.
• Arming / Disarming without using the remote control.
• Remote OFF sensor's levels.
• Remote control of the central lock.
• Management of the central lock from the ignition switch.
• Two-line unlocking of door locks.
• Two pulse unlocking of door locks.
• Ability to implement the "COMFORT" function.
• Four additional control channels.
• Service mode VALET.
• Call mode from the car.
• Separate temperature display in the passenger compartment and under the hood of the car.
• Remote programming of new and erasing lost control panels.
• Remote programming of alarm modes and functions

  Additional channels

• Channel #1
    -trunk opening output
    - pulse with programmable (1-60 sec.) duration
    - pulse with programmable (1-60 sec.) duration and shutdown of sensors
    - impulse "latch" turns on and off from the remote control

• Channel #2
    - two-step opening of door locks
    - pulse with programmable (1-60 sec.) duration
    - pulse with programmable (1-60 sec.) duration
    - impulse "latch" turns on and off from the remote control

• Channel #3
    - impulse 0.7 seconds
    - pulse with programmable (1-60 sec.) duration
    - pulse with programmable (1-60 sec.) duration
    -iImpulse "latch" turns on and off from the remote control

• Channel #4
    - impulse with programmable (1-60 sec.) duration when disarmed
    - arming 13 sec. impulse
    - pulse with programmable (1-60 sec.) duration when arming
    - arming 13 sec. impulse

  Electrical parameters

Supply voltage: 9-15 V DC
Standby Current: ~ 15 mA
Temperature range -30 ° C ... + 75 ° C
Maximum current in circuits
    - parking lights relay: 10A
    - central doors locking relays: 15A
    - blocking engine relay: 15A

  Management of Engine Start (Model BS-555 ST only)

• Remote engine start / stop
• Remote extension of a running engine
• Automatic engine start by temperature, alarm, timer
• Choice of engine type: gasoline / diesel
• Automatic / mechanical gear type selection
• Monitoring the engine according to the tachometer, generator, voltage of the onboard network
• Automatic protection against restarting the starter when starting the engine
• Indication of the running time of the running engine on the remote control display

  Gallery